B.E-B.E Aeronautical Engineering Aircraft General Engineering and Maintenance Practices (Sathyabama University, Chennai, Tamil Nadu-2010)
Friday, 23 August 2013 01:51Duraimani
(Established under section 3 of UGC Act,1956)
Course & Branch :B.E - AERO
Title of the Paper :Aircraft General Engineering and Maintenance Practices Max. Marks :80
Sub. Code :526605/626605 Time : 3 Hours
Date :03/05/2010 Session :FN
PART - A (10 x 2 = 20)
Answer ALL the Questions
1. How do you hoist the airplane?
2. Write the pre-start procedure of turboprop engines.
3. Write the precautions observed in chemical oxygen system.
4. Components of Gas turbine lubricating system.
5. Write short notes on “GPU”.
6. What are the types of cleanrooms?
7. How publications are useful in aviation industry?
8. What is the purpose of inspection?
9. What are reamers, drills, dies and tapes?
10. List the different types of gears.
PART – B (5 x 12 = 60)
Answer All the Questions
11. What is mooring? How will you moor an aircraft and what are the precautions observed.
(or)
12. What is fire? Types of fire. Write down the procedure for fire extinguishing and the types of fire extinguishers.
13. What are the types of oxygen system generally used in aircrafts. Explain briefly.
(or)
14. What is the need of lubrication? Explain briefly about reciprocating engine oil system.
15. (a) What documents should the aviation maintenance technician refer regarding the potential hazard when dealing with hazardous materials?
(b) What are the safety precautions to be observed while working on aircraft oxygen system?
(or)
16. Explain the cable swaging procedure in detail. List out the advantages of swaging over splicing.
17. What is meant by “Check List”? How will you prepare a check list for inspecting a jet engine aircraft? Explain step by step.
(or)
18. Write short note on
a) IPC, Publications & Bulletins.
b) Maintenance Manuals.
c) Overhaul Manuals.
d) Structural Repair Manuals.
19. (a) With neat sketch what are hand tools used in aviation industry.
(b) Explain the piston engine starting procedure in detail.
(or)
20. (a) Explain briefly the types of bearings.
(b) What is trouble shooting?
(c) American and British system of specification.
(d) Identification of fluid line fittings.
| Earning: ₹ 3.15/- |
