North Maharashtra University 2010 B.E Instrumentation Technology Jalgaon, ,Instrumentation - Question Paper
Monday, 04 February 2013 05:20Web
Seat No.___________
PROCESS INSTRUMENTATION(New)
Time:3 Hours Max.Marks:100
__________________________________________________________________________________
Istructions: 1)Do not write anything on ques. paper other than Seat No.
2)Solve any 2 ques. from every unit.
3)Figures to the right indicate full marks.
4)Neat diagram must be drawn wherever nesessary.
5)Assume suitable data if necessary.
__________________________________________________________________________________
UNIT-I
1. a)Explain multicapacity process in detail. define interacting loop and
non interacting lags. [Marks 10]
b)Explain subsequent process characteristics: [Marks 10]
i) Steady state gain.
ii)Process gain.
iii)Variable pressure drop.
iv)Transmitter gain.
c)Explain constant step analysis method for finding time constant with an
example. [Marks 10]
UNIT-II
2. a) i) discuss with sketch flow control loop. [Marks 10]
ii) discuss with sketch level control loop.
b)Explain in detail PID Controller. [Marks 10]
c)For non linear controller discuss following: [Marks 10]
i)Describing function
ii)Limiter
iii)Dead Zone
iv)Dead band.
UNIT-III
3. a)Explain with sketch ratio control loop in detail. [Marks 10]
b)Explain with sketch selective control loop. [Marks 10]
c)State and discuss what do you mean by decoupling.Describe any 1 method
of decoupling. [Marks 10]
UNIT-IV
4.a)Explain with sketch 3 element drum level control. [Marks 10]
b)Explain with sketch furnace control of heat exchanger. [Marks 10]
c)Explain with neat diagram about burner management and control. [Marks 10]
UNIT-V
5.a)Draw and discuss instrumentation scheme for compressor control. [Marks 10]
b)Sketch and discuss intrumentation scheme for cooling tower. [Marks 10]
c)Sketch and discuss intrumentation scheme for multi effect evaporator. [Marks 10]
Earning: Approval pending. |