Jawaharlal Nehru Technological University Kakinada 2008 B.Tech Electronics and Communications Engineering LINEAR IC APPLICATIONS - Question Paper
Saturday, 10 August 2013 07:55Web
Page 2 of 3
table of Dual four to one line multiplexer.
(b) discuss the operation of balanced modulator using neat sketch. [10+6]
? ? ? ? ?
2 of 2
Code No: R05310401 Set No. 2
III B.Tech I Semester Supplimentary Examinations, February 2008
LINEAR IC APPLICATIONS
(Electronics & Communication Engineering)
Time: three hours Max Marks: 80
ans any 5 ques.
All ques. carry equal marks
? ? ? ? ?
1. (a) discuss cascade connection of differential amplifier for active load.
(b) Write the properties of various configurations of differential amplifier. [8+8]
2. (a) calculate the maximum possible total output voltages in the amplifier circuits
shown in figure 2. The op - amp is the MC1536 with the subsequent specifica-
tions:
Vio = 7.5mV maximum; Iio = 50nA maximum; IB = 250 nA maximum at TA
= 250C.
(b) discuss the difference ranging from the slew rate and the transient response.
(c) Briefly discuss the need for compensating networks in op - amps. [4+6+6]
Figure 2
3. (a) obtain V0 for the circuit shown in figure 3
(b) obtain R1 and Rf in the practical integrator (lossy integrator), so that the peak
gain is 20 dB and the gain is three dB down from its peak when ? = 10,000
rad/sec. Use a capacitance of 0.01µF. [8+8]
1 of 2
Code No: R05310401 Set No. 2
Figure 3
4. Design and discuss a saw tooth waveform generator using operational amplifier
and plot the waveforms for the provided specifications frequency = 5kHz, Vsat = ±12
Volts. [16]
5. (a) Design a 4th order Butterworth low pass filter whose bandwidth is 1kHz.
choose all capacitors equal to 1000nF.
(b) discuss the operation of narrow band pass filter and find the frequency
response. [8+8]
6. (a) Draw the block schematic of a PLL describing the function of every block
briefly.
(b) What is the purpose of low pass filter in a phase locked loop? define various
kinds of low pass filters used in PLL. [8+8]
7. (a) elaborate the basic blocks preceding an Analog to Digital converter in a typical
application like digital audio recording?
(b) Draw the circuit of weighted resistor DAC and derive expression for output
Earning: Approval pending. |