How To Exam?

a knowledge trading engine...


Yashwantrao Chavan Maharashtra Open University 2006 Certification TML Basic Electrical Engineering - Question Paper

Friday, 01 February 2013 10:35Web


Basic Electrical Engineering

TML031/EE/20070812

Basic Electrical Engineering Time : 180 minutes    Marks : 100

Instructions for the students :

1.    All questions are compulsory.

2.    "Long Answer type Question (LAQ)" is a supply type question of 20 marks, which require typical answer of about 60-80 lines in about 32-40 minutes.

3.    "Short Answer type Question (SAQ)" is a supply type question of 5 marks, which require typical answer of about 15-20 lines in about 08-10 minutes.

4.    Use of non-programmable type of scientific calculator is allowed.

5.    Draw neat diagrams wherever necessary.

6.    Assume suitable data if necessary.

Question (Q)


Questio n Marks


Q-

No


Long Answer type Questions (LAQ's)

10

1.


(a) Find the current flowing through each resistor for given circuit. Resistor R1 is producing 0.075 W of heat, R2 is producing 0.45 W if heat and R3 is producing 0.225 W of heat. The circuit has total current of 0.05 A.

(b) Find the voltage across each resistor for a given series circuit.

10


Q-

No

(a) State superposition theorem. Find the current through R2 in given circuit using super position theorem.

2.


15


5


(b) State Kirchhoff's voltage and current law. Explain with an example.

(a)


3.


15


Calculate the resistor values for an Ayrton shunt for 1A, 500 mA and 100 mA range. The meter movement has full scale values of 50 mV, 1 mA and 50 Q of resistance.


5

(b) Explain the measurement of unknown resistance using Wheatstone bridge.


(a) The phase windings of an alternator are connected in wye. The alternator produces a line voltage of 440V and supplies power to two resistive loads. One load contains resistors with a value of 4 Q each, connected in wye. The second load contains resistors with a value of 6 Q each connected in delta. Find-

4


20


i) EL (Load 2) ii) Ep (Load 2) iii) Ip (Load 2) iv) IL (Load 2) v) Ep (Load 1) vi) Ip (Load 1) vii) IL (Load 1) viii) IL (Alt) ix) Ep (Alt) x)True power P.

(a)    State the Coulomb's law.

(b)    Define Volt Amp (VA)

Convert the given circuit into its Thevenin's equivalent circuit.

6.


5


Write a short note on Wattmeter.

7.


5


A sine wave has a maximum voltage of 350 V. At what angle of rotation will the voltage reach 53 V ?

8.


5


N-71    TML031/EE/20070812: 3







Attachment:

( 0 Votes )

Add comment


Security code
Refresh

Earning:   Approval pending.
You are here: PAPER Yashwantrao Chavan Maharashtra Open University 2006 Certification TML Basic Electrical Engineering - Question Paper