How To Exam?

a knowledge trading engine...


University of Mumbai 2008-3rd Sem B.E Electrical and Electronics Engineering Electrical Networks - Question Paper

Sunday, 14 July 2013 11:10Web


Electrical Networks Sem III June 2008

[ Total Marks : 100

Con. 3488*08.

(REVISED COURSE)

(3 Hours)

N.B. (1) Question No. 1 is compulsory.

(2)    Attempt any tour questions from remaining.

(3)    Assume suitable data if necessary.

Iw/ nSaUillC SUItOUlC UBlfi II ncCcaSBry.    ft    I O I f f

{hTZu/ K7-u>lca    " -41

1. (a) For me circuit C1, find the posvef delivered by dependent current source

(b) Use Superposition theorem to find voltage v2 in circuit C2.

cicu-iJ c

(c) Write short notes on Initial Conditions.

2. (a) Find the drop across 10 O resistor for circuit C3

(b) The reduced incidence matrix of an oriented graph is given

(i)    Draw the graph.

(ii)    How many trees are possible ?

A -

3. (a) Switch in circuit C4, is changed at t = 0 from position 1 to 2, solve for 1(1).

(b) For the circuit C5. determine the maximum power delivered to toad impedance ZL.

T. (a) Determine t,, <Jit/dr. Oi/ai, du/dPTnd cFy'dt* for circuit Cb.

(b) The circuit C7 is in position 1 at t = 0, after t = 3 J switch is changed to position 2. find the transient current !(t) for

(i) 0 < t < 3J    and (II) t > 3J (J -* time oonstant)





L

5. (a) For the circuit C8. find the value of unknown impedance provided no current flows in branch y.

|b) A three phase, three wire, 100 V, ABC system supplies a balanced delta load with impedance of 20 /. 45 U :

(I) Determine the phase and line currents and draw the phasor diagram.

(H) Find the wattmeter readings when two wattmeter method is used. (Hefer C9)

cxaJ" 3

6. (a) Using the Compensation theorem* calculate the change in current in the circuit C10, when reactance is change to j35.

(b) Demonstrate the reciprocity theorem by computing Ix for circuit C11.

X*-

-J

2

cj V CJJUi-i C.1 O

ci f cuu c ' *

7 (a) Explain how reactive power can be measured with the help of wattmeter.

(b) What do you mean t>y critical resistance, explain the terms over damped, under damped and critically damped system with JMpoet to series RLC circuit.







Attachment:

( 0 Votes )

Add comment


Security code
Refresh

Earning:   Approval pending.
You are here: PAPER University of Mumbai 2008-3rd Sem B.E Electrical and Electronics Engineering Electrical Networks - Question Paper