Kerala University 2005 B.Tech Architecture PRODUCTION DRAWING - Question Paper
K
Reg. No.
Name....
(3 pages)
L 6081FOURTH SEMESTER B.Tech. DEGREE EXAMINATION NOVEMBER/DECEMBER 2004
PRODUCTION DRAWING (P)
(1998 Scheme)
Reg. No.
Name....
(3 pages)
L 6081Maximum : 100 Marks
Time -. Three Hours
Note : (1) (2)
(3)
(4)
Only First Angle Projections to be used.
Standard conventions must be used.
Any missing dimensions may be suitably assumed.
Credit will be given for neatness and accuracy.
Part A
1. Determine fundamental deviation, tolerances and limits of size for Hole and Shaft in 60 mm. H8 f-1 fit. Draw a neat sketch and show the details.
Or
2. A slip bush shown in the figure is to be manufactured. Prepare a production drawing incorporating the following requirements :
(i) Finish the inside (<j> 30) and outside (<|f 42) cylindrical surfaces to a roughness value of
0.8 nm. All the remaining surfaces are supposed to be a roughness value of 6.3 pim.
(ii) Outside diameter of tbeJbusk-skoa-iMwenft-concentricity tolerances of0.02~ffiffi. witli the axis of the cylindrical hole of <|> 30.
(iii) Inside diameter of the bush should have an upper and lower deviations of +0.028 mm. and +0.015 mm. respectively while the outside diameter has a tolerance of h 6. Redraw the given figure and indicate all the above informations on the drawing symbolically as per B.I.S.
sap bush (20 marks)
Turn over
2 L 6081
Part B
3. Details of a Lathe-Tail stock are shown in the accompanying figures. Assemble the parts and draw the sectional elevation marking the dimensions.
(80 marks)
/ |
// | |||
1__ |
0----'"~ |
/
|
|
L 6081
(ENLARGED) |
* MJOaSlH "m- =5XS /iyARE {Hfiggir
0Rj<eri
X &(' |
100 |
10
*-J- H11*>
i?
(tNlARGtD) -40
(u)
.(ENLARGED) |
_____!12____
!<
i_
- a
M fOx S IH / square'Thread | |
WAT FOR /PARAllCl KEY Sit5 WAY FOR WRALCeL'KgYSKS | |
N * 10 |
% 1
. j $Lr<S>
(ENLARGED) / U A-
D
VV-
ccfr
\uS- --\ / |
(ENi ARC03 >_ |
A-A L,3-J
(ENLARGED) V-
S \ . . -Jrji
t,r's \ ) Pi; -. , * 1.; . ... *!
N 'jJp -L
A it
Uu
Attachment: |
Earning: Approval pending. |