Mahatma Gandhi University (MGU) 2007 B.Tech Electronic Instrumentation & Control Engineering linear and digital ic lab - Question Paper

LINEAR AND DIGITAL IC LAB
ELECTRONICS AND INSTRUMENTATION
FIFTH SEMESTER

1. Op amp configurations –inverter, non inverter
2. Op amp applications- summer, subtract or, integrator, differentiator
3. Design and testing of instrumentation amplifier
4. Design and testing of precision rectifier
5. Design and testing of active filters
6. Design and testing of waveform generators using op amps- square, triangular
7. Design and testing of multi vibrators using 555
8. Simplification of a logic function and its realization using (1) AND, OR, NOT gates and (2) universal gates

9. Design and analysis of adder & subtract or
10. Design of code converters a) binary to gray b) binary to excess c) BCD to decimal
11. Verification of truth tables of JK, RS, D and T flip flops
12. Design of synchronous counters and sequence generators
13. Shift registers
14. Multiplexer and Dee multiplexer

TRANSDUCERS AND MEASUREMENTS LAB

1. LDR and opt coupler characteristics
2. RTD and thermostat characteristics
3. Strain gauge and load cell characteristics
4. LVDT and taco generator characteristics
5. Thermocouple characteristics and cold junction compensation
6. Vibration measurement and analysis
7. Capacitor transducers and IC temperature sensor
8. Measurement lab
9. Measurement of L C R using bridges
10. Measurement of wind speed using anemometer
11. Measurement of speed- contact and non-contact kinds
12. Measurement of viscosity using redwood viscometer
13. Measurement of water conductivity
14. Measurement of earth resistance

Earning:   Approval pending.