Karnataka State Open University (KSOU) 2009 Diploma Statistics Statistical Process Control - - Question Paper
IHHIHHI SPC 03
Diploma in Statistical Process Control and Operations Research (DSPCOR) Examination, August 2009 STATISTICAL PROCESS CONTROL
Time : 3 Hours Max. Marks : 90
SECTION - I
Answer any 2 questions and each question carries 15 marks.
1. Explain the quality function of a firm.
2. Explain the rules involved in the interpretation of patterns on the control chart.
3. a) What are defects ? Explain through sample.
b) What chart you specify for defects and describe the steps in construction of the chart where process standards are known ?
4. Explain the different types of sampling plans and the rules involved in the formation of lot.
SECTION - II
Answer any 4 questions and each question carries 10 marks :
5. a) What is process variability and define chance and assignable causes of process
variability ?
b) What is cause and effect diagram ?
6. Explain the two types of quality characteristics used in the construction of control charts.
7. Set up x and R charts and write your comments : | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
8. What chart you specify for control chart for defectives and write the control limit for :
i) Process standards are known.
ii) Process standards are not known.
9. The number of nonconforming door hings found in 15 samples of size 300 are shown in the following table :
Sample No. : 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
Non : 10 14 12 16 11 14 8 9 7 15 10 16 12 7 20
Obtain the np-chart.
10. Explain the acceptance inspection.
11. Define and draw the graph for ATI and AOQ and specify AOQL.
12. Define DSP for attributes and steps involved it.
SECTION - III Answer any 4 questions and each question carries 5 marks.
13. What is TQM ?
14. Explain the Pareto chart with an example.
15. What are the advantages of constructing a control chart ?
16. Explain the rational subgroups.
17. What is a statistic ? Explain its role in the construction of a control chart.
18. What is U-chart and write the control limits for it.
19. Explain OC curves.
20. What are ATI and AOQ ?
Attachment: |
Earning: Approval pending. |