Manipal University 2008 B.E Mechanical Engineering FIFTH SEMESTER %28MECHANICAL ENGG.%29 END SEMESTER S- SUBJECT %3A MECHANICAL DESIGN %26 DRAWING %28MEE-307%29 %28REVISED CREDIT SYSTEM%29 - Question Paper
FIFTH SEMESTER B.E. (MECHANICAL ENGG.) DEGREE END SEMESTER exams
JUNE - 2008
SUBJECT : MECHANICAL DESIGN & DRAWING (MEE-307)
(REVISED CREDIT SYSTEM)
Reg. No. |
MANIPAL INSTITUTE OF TECHNOLOGY
(A Constituent Institute of Manipal University, Manipal)
ITT
FIFTH SEMESTER B.E. (MECHANICAL ENGG.) DEGREE END SEMESTER EXAMINATIONS
JUNE - 2008
SUBJECT : MECHANICAL DESIGN & DRAWING (MEE-307) (REVISED CREDIT SYSTEM)
10/06/2008
MAX.MARKS: 50
Time: 4 Hours.
Instructions to Candidates
Answer BOTH the questions
Design Data Handbook is permitted
Additional data required may be appropriately assumed
Assumptions made must be clearly mentioned
1. Draw involute tooth profile for a pair of spur gears, showing at least 2 teeth on each gear. Gears have the following specifications
Tooth profile : 20o full depth
No. of teeth on pinion : 20
Gear ratio : 1.2
Module : 10 mm 15
2. Design the connecting rod for a petrol engine having the following specification Indicated power at 1600 rpm = 25 kW Stroke length = 220 mm
Speed = 1600 rpm
Compression ration = 8
Mean effective pressure = 1.45 MPa
maximum explosion pressure = 2.45 MPa
Draw two views of the connecting rod and show two views of the connecting rod
OR
Design a centrifugal pump impeller to lift 90 liters/s of water with an effective head of 15m. Motor speed is 1440 rpm and ratio of impeller diameters is 0.5 . What type of vane is recommended and why ? Draw two views of the impeller. 35
(MEE-307)
Page 2 of 1
Attachment: |
Earning: Approval pending. |