Ch. Charan Singh University 2008 B.C.A Computer Application Production

(2019) Roll. No. ………………..
BCA (III Sem.)

3106

B.C.A Examination, Dec-2008
Production & Operations Management
(BCA-304)
Time: 3 Hours Maximum Marks: 75
Note: Attempt any 5 ques.. All ques. carry equal marks


1. (a) describe Operations Management and discuss briefly its applications.
(b) explain the significance and scope of Operations Management in modern
Management.

2. (a) The subsequent table indicates the number of missing rivets observed at the time of inspection of 12 aircrafts. obtain the control limits for the number of defects charts and comment on the state of control:

Aircraft No.:
1 two three four five six seven eight nine 10 11 12
No. of missing rivets:
7 15 13 18 10 14 13 10 20 11 22 15

(b)The PLC of many products does not follow the typical bell shaped curve. discuss why?


3. (a) Write shorts note on the following:
(i) Product Support Services
(ii) Back flushing in a Just- in-time system.
(b)Explain the concept of “ABC Analysis” as a technique of inventory control

4. (a) State how you would treat the subsequent in cost records:
(i) Pricing of materials returned to stores, and
(ii) Pricing of materials returned to suppliers.

(b)The rate of interest is 12%, the price per unit is Rs. 50, the number of units needed in a year is 5,000 and the cost of placing 1 order and receiving the goods once is Rs. 54. How much should be purchased at a time?

5. (a) What is meant by plant layout? Differentiate ranging from process and product layout.
(b) What do you mean by Acceptance Sampling?

6. What are the steps to be taken in the implementation of TQM?

7. Explain briefly the methods of operation of Material requirement planning system.

8. Discuss the factors affecting the location of a Cement manufacturing plant.

9. What is plant layout? elaborate the advantages and limitations of product layout?

10. Write short notes on the following:
(i) Product Design
(ii) Service Design
(iii) Quality Assurance.

Earning:   Approval pending.