B.Tech-COMPUTER SCIENCE AND ENGINEERING 1st Sem MANUFACTURING PROCESS(Guru Gobind Singh Indraprastha Vishwavidyalaya, Delhi-2009)
Saturday, 25 September 2010 11:37garima
- Explain the following types of sand:
- 1.Facing sand 3. System sand
- 2. Backing sand 4. Parting sand
- Why does the section of sprue reduce downwards? 3
- What is the importance of permeability in molding sands? 2
- Imagine a gating system without a riser. How does it affect the casting? 2
- What is the difference between hot chamber and cold chamber die casting? Explain one process with suitable diagrams. 8
- Explain centrifugal casting? How are the centrifugal casting methods classified? 3
- Why is the mold in permanent mold casting preheated? 4
Q3
- Define "forgeability". On what factors does it depend? 3
- Write short notes on swages, tongs and flatters used in a forging shop. 4
- What is upset forging and how is it done? 4
- How are a forging hammer and drop hammer alike and how do they differ? 5
Q4
- Sketch and explain the working of an engineer's try square? 6
- What are the advantages of a twist drill over flat drill? 4
- What is the significance of accurate marking? 3
- What is the difference between a mallet and a hammer? 2
- Describe hems and seams used in sheet metal work. 6
- Explain the utility of various allowances for making components by sheet metal work. 3
- Differentiate between piercing, punching and blanking. 6
- With the help of neat sketches explain the "spot welding method". 5
- Sketch the two polarities of DC supply and compare these for welding process. 4
- What is the purpose of coating on an arc welding electrode? 3
- Sketch the three types of flames used in oxy-acetylene. Gas welding give the uses of each. 3
- Various edge preparations used for welding joints. 3x5
- Difference between welding, soldering and brazing.
- Types of files.
- Binders used in molding sand.
Earning: ₹ 4.00/- |